Ensotech Swave-W3 sensored brushless ESC

Swave-W3, the ultimate sensor-type electronic speed controller for microscale 1:24 and 1:28 R/C cars, gives the best liner and responsiveness on drifting and touring races. Enjoy the best value versus performance ratio, size, weight, technology, and other advantages.
What is new compared to Swave-W2?
* Truth 25A continuous current to 35A peak current
* Equipped with a performance capacitor to sustain power flow and no longer requires hesitation work to install an external capacitor.
* Selectable 5.0V and 6.5V BEC output power for different types of servos.
* A new battery management system maintains the output consistently until the last, even with low-quality batteries.
* Lower operating temperature

This combo pack introduces a new generation Bluetooth adaptor ENSO BLUTH-MT with Swave-W3. It is a high-volt Bluetooth ideal for Swave-W3 with a 6.5V BEC output. A single Bluetooth can communicate with IOS also with Android.


CAUTION if using first-generation ENSO BLUTH and ENSO BLUTH-II (5.0V Bluetooth adaptor) on Swave-W3:
ENSO BLUTH and ENSO BLUTH-II are 5.0-volt first-generation Bluetooth adaptors. To avoid adaptor burn on Swave-W3, you first need to use the new ENSO BLUTH-MT or Android Ultralink programming cable to change the BEC voltage to 5.0V and successfully upload the new setting to esc. Then power off the esc before switching over.

NOTE: BEC simultaneously powers Bluetooth and servo. To use 5.0V Bluetooth, the servo is gained by 5.0V only.